There are a few ways to rename a prototype in UXPin: You can read about it below in the Import files to UXPin section. The prototype will be created and opened automatically.Īnother way is to upload a prototype through the file import or by dropping the file onto your dashboard. To add a new prototype to a project click Create another prototype in the bottom left corner of the Project Dashboard. They are all grouped on the Project Dashboard. Set Conversion Tolerance to 0.001in or 0.0254mm.All your designs, prototypes, mockups and wireframes inside your Projects are what we call Prototypes.Enter 0.001mm for Max Deviation Distance.The field will be replaced by minimum acceptable value.Vertex Spacing - This option controls the length of the edge of a facet.Ī setting of 0.0000 causes this option to be ignored.Surface Tolerance - This setting controls the greatest distance between the edge of a facet and the actual geometry.A setting of 1 would mean the height of a facet is no greater than its width. Aspect Ratio - This setting controls the Height/Width ratio of the facets.Reducing the angle will increase the resolution of the STL file. Angular Tolerance - This command limits the angle between the normals of adjacent triangles.The following command line options affect the quality of the STL and should be adjusted to produce an acceptable file.Use the AMSTLOUT command to export your STL file.Set absolute facet deviation to 0.000395.Select Prototype Device >SLA500.dat >OK.Choose Stereolithography from Export options.Make sure the model is in positive space.Your design must be a three-dimensional solid object to output an STL file.Should Quickparts determine that your STL file is not adequate for production, we will contact you for an updated file.) Please consult your users guide or the software's developers for more information or technical support. (Please note, these are only general guidelines and may not work or produce the best possible STL file in some cases. An exception is the High Resolution SLA, which will make features down to 0.010 and the SLS Flex material, which needs 0.040 thickness to produce features. Please check your models and make appropriate changes to critical features. Anything less then this and features will not develop.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |